CURE & SEAL
Cure & Seal is a fast drying, clear, water
based epoxy primer/sealer for damp or dry concrete surfaces. It is designed for maximum resin
penetration into the concrete and provides a thin mil, abrasive resistant,
protective wear surface. Cure &
Seal bonds tenaciously to properly prepared concrete. Cured films are resistant
to mild chemicals and provide an excellent primer for additional coatings . Cure & Seal can be installed within 2
days of pouring new concrete. 100%
solids epoxy can be installed as soon as Cure & Seal is tacky or dry (within a
few hours.) Cure & Seal eliminates
the need to wait 28 days prior to the installation of 100% solids epoxy.
 | - Easy to apply (brush, roller or
airless sprayer.) |
| - Penetrates deeply into concrete.
|
| - Provides film coat protection. |
| - Prevents concrete from dusting. |
| - Ideal prime coat for 100% solids
coating/flooring. |
| - Excellent adhesion. |
| - Hardens newly poured concrete. |
| - VOC compliant; no strong odors. |
Application Instructions:
| - Surface must be properly prepared -
structurally sound, clean (dust, oil, and grease free.)
|
| - Surface can be damp; however there can
be no standing water. |
| - Mix ratio: 2 parts Part A: 1 part Part
B, by volume (2:1) |
| - Induct mixture for 30 minutes before
applying. |
| - After induction, pot life is 1 hour. (Do not use material after) |
| - Apply at the rate of 400 to 1000 square feet per gallon |
| - Do not allow material to puddle. |
BEDROCK “CURE & SEAL”
PHYSICAL PROPERTIES / TECHNICAL DATA
| Mix Ratio | 2:1 by volume |
| Pot Life | 1 hour |
| Induct | 30 minutes |
| Initial set | 1 to 3 hours |
| Color | Clear |
| Direct Impact | 140 in-lbs |
| Reverse Impact | 25 in-lbs |
| Taber Abrasion | 164 mg loss |
| Pencil Hardness | 2H |
| Solids (weight) | 39.1 |
| Solids (volume) | 37.1 |
| VOC | 58 gms/liter |
| Density | 8.8 lbs/gallon |
| Coverage | 400 to 1000 sq.ft. per gallon |
| Shelf Life | 1 year in unopened
container
Do not allow to freeze. |
Chemical Resistance
| 10% Ammonia | No effect |
| Water | No effect |
| Ethanol | Loss of gloss |
| Formula 409 | No effect |
| Windex | No effect |
| 15% Sodium Hydroxide | No effect |
| Gasoline | Slight softening |
| Xylene | Slight softening |
“Warranties: Seller
warrants that its goods, as described on the face hereof, are free from any
defect in material or workmanship.
Seller makes no other warranty, expressed or implied, and all implied warranties
of mercantibility and fitness for a particular purpose are hereby disclaimed. Seller shall not be liable for
prospective profits or special indirect or consequential damages. Seller’s sole liability and buyer’s exclusive remedy for
breach of any warranty is expressly limited, at seller’s option, to replacement
at the original F.O.B. point or refund of purchase price. Seller shall not be responsible for any claim resulting from
failure to utilize product in the manner in which it was intended and in
accordance with instructions provided for use of product. Any claim for breach of warranty shall
be deemed waived unless buyer shall give seller written notice of such claim
within (60) days after delivery and shall allow seller reasonable opportunity to
investigate claim and inspect product.”