|
|
Bedrock Binder
DESCRIPTION:
Bedrock Binder is a
100% solids (solvent & water free), two component, structural epoxy,
primarily used for coating and resurfacing damaged concrete.
It is used for waterproofing and protecting floors against corrosion and
deterioration caused by water, chemicals and heavy traffic.
BASIC USES:
Bedrock Binder can be
mixed with sand to make a trowelable mortar.
GRADES AVAILABLE:
Standard, Trowel, Non Sag Cove Base,
ADVANTAGES:
 |
EASY TO MIX AND
TROWEL |
|
100% SOLIDS
FORMULA (NO SOLVENTS) |
|
EXCELLENT
ADHESION TO CONCRETE, STEEL AND WOOD |
|
NO SHRINKAGE |
|
CLEAR AND ALSO
AVAILABLE IN COLORS |
|
EXCELLENT
CHEMICAL RESISTANCE |
|
EXCELLENT FOR
GROUTING BOLTS AND REBAR |
INSTALLATION:
CLEANING: Area must
be clean, sound and dry. Conventional
cleaning methods used are acid etching, shot-blast, or aqua-blast.
Dense concrete should be acid etched exposing small aggregate particles
and giving the appearance of sandpaper.
PRODUCT
MIXING:
-
Stir each component separately.
-
Blend 2 parts base to 1 part reactor by volume and mix completely.
-
When preparing mortar, mix in 3-4 parts of aggregate by volume using a slow speed electric drill with paddle.
BEDROCK
BINDER / WITH 3 PARTS AGGREGATE
PHYSICAL
PROPERTIES / TECHNICAL DATA
| Mix Ratio | 2:1 by volume |
| Pot Life | 45minutes @ 77degrees F. |
| Initial Set Time | 6 - 8 hours @ 77 degrees F. |
| Color | Various Colors |
| Compressive Strength (ASTM D695) | 10,500 psi minimum @ 7 days |
| Tensile Strength (ASTM D 638) | 1750 psi minimum |
| Tensile Elongation (ASTM D 638) | 3 percent |
| Tensile Shear | 28 days @ 77 F. 1800 psi minimum. |
| Hardness Shore D (ASTM D 2240) | 85 - 90 |
| Flexural Strength (ASTM C 882) | 4,500 psi |
| Bond Strength (ASTM C 882) | 100% concrete failure |
| Indention (MIL-D-3134F) | No Indention |
| Abrasive Resistance (ASTM D 1044) | .19 gram max. |
| Water Absorption (ASTM C 413) | .1% |
| Viscosity | Mortar |
| Shelf Life | 2 years in unopened container |
CHEMICAL RESISTANCE:
Resistant to mild
acids, alkalies, detergents, solvents, skydrol, hydraulic fluids, lubricating
oils, deicing salts, etc.
“Warranties: Seller
warrants that its goods, as described on the face hereof, are free from any
defect in material or workmanship. Seller
makes no other warranty, expressed or implied, and all implied warranties of merchantability
and fitness for a particular purpose are hereby disclaimed.
Seller shall not be liable for prospective profits or special indirect or
consequential damages. Seller’s
sole liability and buyer’s exclusive remedy for breach of any warranty is
expressly limited, at seller’s option, to replacement at the original F.O.B.
point or refund of purchase price. Seller
shall not be responsible for any claim resulting from failure to utilize product
in the manner in which it was intended and in accordance with instructions
provided for use of product. Any
claim for breach of warranty shall be deemed waived unless buyer shall give
seller written notice of such claim within (60) days after delivery and shall
allow seller reasonable opportunity to investigate claim and inspect product.”