Flexi-Coat ] Bedrock Binder ] [ Rockote ] Best Cleaner/Degreaser ] Stone Saver ] Safety Grip ] Troweled Epoxy Flooring ] Cementious Self-Leveling ] Broadcast Flooring ] Bedrock Patch ] Cure & Seal ]

Rockote

Rockote is a high strength epoxy coating designed especially for sealing new or used concrete floors.  It is also an excellent topcoat material over most epoxy flooring systems.  This two component 100% solids epoxy provides a tough, sealed, non-porous surface. It can be installed from 10 mils to any desired thickness in one or more coats without effecting its properties.  Rockote resists abrasions, oil, gasoline and many diluted acids and solvents.  Various textures are available, ranging from skid-resistant to smooth.

 BENEFITS:                                                                           

Tenacious adhesion better than urethane or acrylic sealers.

Stops water and moisture from penetrating concrete.

Available in water clear or pigmented.

The high gloss finish reflects a greater amount of light.

Prevents floors from dusting.

Easy cleaning and maintenance.

Easy application.

 

TYPICAL USES:

Epoxy sealer is suitable for use in:

Warehouses
Auditoriums 
Battery rooms 
Loading docks 
Walkways   
Machine shops  
Parking ramps
Bottling plants
Garages and hangars
Service stations
Car wash areas
Laundries

LIMITATIONS:

bullet

Do not apply at temperatures below 50 degrees F.  

bullet

Mix only amounts that can be applied in 30 minutes.

bullet

Surface must be properly prepared before application.


   BEDROCK “ROCKOTE”

PHYSICAL PROPERTIES / TECHNICAL DATA

 

Mix Ratio  2:1 by volume
Pot Life   30 minutes @ 77 degrees F.
Initial Set  6 - 8 hours @ 77 degrees F.
Color  Clear or Pigmented
Compressive Strength (ASTM D 695)  12,500 psi minimum @ 7 days
Tensile Strength (ASTM D 638)  3950 psi minimum
Tensile Elongation (ASTM D 638) 5%
Hardness Shore D (ASTM D 2240)  85 - 90
Flexural Strength (ASTM D 790) 24,500 psi
Indentation (MIL-D- 3134F) No Indentation
Abrasive Resistance (ASTM D 1044)  .040 grams
Taper Abrader c-10 Wheel  
100 gram load 1,000 cycles  
Water Absorption (ASTM C 413)    .1%
Coverage (16 mils thick) 100 sq.ft./gallon (theoretical)
Shelf Life   2 Years in unopened container

 

“Warranties: Seller warrants that its goods, as described on the face hereof, are free from any defect in material or workmanship.  Seller makes no other warranty, expressed or implied, and all implied warranties of merchantability and fitness for a particular purpose are hereby disclaimed.  Seller shall not be liable for prospective profits or special indirect or consequential damages.  Seller’s sole liability and buyer’s exclusive remedy for breach of any warranty is expressly limited, at seller’s option, to replacement at the original F.O.B. point or refund of purchase price.  Seller shall not be responsible for any claim resulting from failure to utilize product in the manner in which it was intended and in accordance with instructions provided for use of product.  Any claim for breach of warranty shall be deemed waived unless buyer shall give seller written notice of such claim within (60) days after delivery and shall allow seller reasonable opportunity to investigate claim and inspect product.”

 

Email: info@bedrockresin.com            sales@bedrockresin.com

Bedrock Resin Corp. 164 Central Avenue, Farmingdale, NY 11735 1 (866) 345-EPOXY Toll Free